LQSE-4T5-120-D
SPECIFICATION SUBMITTAL Page
Job Name: Model Numbers:
HomeWorks QS 0 – 10 V- Power Module
3691054b 2 02.21.18
Job Number:
Specifications
Power
• 120 V~ 50/60 Hz
• Lightning strike protection meets ANSI/IEEE standard
62.31–1980. Can withstand voltage surges of up to
6000 V~ and current surges of up to 3000 A.
Regulatory Approvals
• Lutron Quality Systems registered to ISO 9001:2015
• cULus Listed
• NOM Certified
Environment
• Ambient Temperature Operating Range (inside
mounting panel): 32 ºF to 131 ºF (0 ºC to 55 ºC)
• Calibration point maximum: 149 ºF (65 ºC)
• Relative humidity: less than 90% non-condensing
• For indoor use only
Output Zone Ratings
• Each zone is rated at 5 A for switching (maximum of
20 A per module). Rated for incandescent, ELV, MLV,
and electronic ballast lighting loads.
• Switched outputs utilize latching relays to maintain relay
state if control power is lost.
• 0 –10 V- rated for 50 mA maximum output, source or
sink per zone.
• For applications requiring higher wattage ratings, use
the PHPM-SW-DV-WH interface.
• For applications requiring 16 A 3-wire ballast dimming
or phase adaptive dimming use the following interfaces:
– BCI-0-10
– BCI-0-10 + PHPM-WBX-120-WH
– BCI-0-10 + PHPM-WBX-DV-WH
Terminals (Torque, wire gauge & type ratings)
• Mains wiring: 5.0 in-lbs (0.6 N•m)
- 16 AWG to 10 AWG (1.0 mm
2
to 4.0 mm
2
)
(single wire, solid or stranded)
• Zone Wiring: 5.0 in-lbs (0.6 N•m)
- 16 AWG to 10 AWG (1.0 mm
2
to 4.0 mm
2
)
(single wire, solid or stranded)
• CCI Wiring: 5.0 in-lbs (0.6 N•m)
- 20 AWG to 10 AWG (0.5 mm
2
to 4.0 mm
2
)
(single wire, solid or stranded)
- 20 AWG to 16 AWG (0.5 mm
2
to 1.0 mm
2
)
(two wires, solid or stranded)
• 0 –10 V- wiring: 5.0 in-lbs (0.6 N•m)
- 20 AWG to 16 AWG (0.5 mm
2
to 1.0 mm
2
)
(single wire, solid or stranded)
• QS link: 5.0 in-lbs (0.6 N•m)
- Power: 20 AWG to 10 AWG (0.5 mm
2
to 4.0 mm
2
)
- Data: 1 twisted, shielded pair 22 AWG to 18 AWG
(0.34 mm
2
to 0.75 mm
2
)
- See Wiring: QS Link section on page 9
HomeWorks QS Wallstations
• HomeWorks QS wallstations can be configured to
control Power Modules with the HomeWorks QS
programming utility.
• LED indicator displays the status of programmed
lights.
QS Link Limits
• A QS link in a HomeWorks QS system can have up
to 512 zones (outputs) and 100devices.
• Each 0 –10 V- power module counts as one device
toward the 100 device limit, and up to 4 zones
toward the 512 zone limit.
