12/58294 August 2012 2
Nature of waste (if known) – please note whether concentrations are average or maximum values
Chemical Oxygen Demand (COD) – mg/L
Total Kjeldahl Nitrogen (TKN) – mg/L
Suspended Solids (SS) – mg/L
Other parameters applicable to industry:
Volume and rate of discharge
Average daily volume (m
3
)
Maximum flow rate (L/sec)
Daily/seasonal variation (if any)
Proposed method of flow measurement:
Calibrated meter (e.g. mains/internal supply) Manufacturer specification Other (please specify)
Please include any supporting information you may have, i.e. existing certification relevant to industry, relevant
management plans, chemicals used on site, etc. As-built plans (or sketch where appropriate) of the drainage system
is required.
Compliance statement (to be completed by executive representative of registered company)
The discharge referred to in this application complies with all conditions of the Trade Waste Bylaw 2012. The discharge
does not contain any substances which are specifically prohibited under Schedule 1B of the Trade Waste Bylaw 2012.
I understand that under Section 4.10 of this bylaw, failure to limit trade waste discharges to within the parameters
specified in Whangarei District Council’s Trade Waste Consent or Special Agreement issued under this bylaw can be
reasonable grounds for cancellation of this consent
Designation (please print)
Organisation (please print)
Site plans/sketches attached
Additional documents attached
NB: Application fee(s) apply.