Custom Combination PanelsGRAFIK SystemsT Power Equipment
369999a 4 09.02.2016
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Sources/Load Types
Operate these sources with a smooth, continuous
Square Law dimming curve or in a full-conduction,
non-dim state:
LP Dimming Modules
• 80 BTU/hour maximum per module.
• RTISS
TM filter circuit technology compensates for
incoming line voltage variations: No visible icker with
+/− 10% change in RMS voltage/cycle and +/−2% Hz
change in frequency/second.
• CE model is rated to for a max load of 13 A per
module, with a maximum of 13 A on an output.
• Non-CE model is rated for 16 A per module, with a
maximum of 16 A per on an output.
• Can operate HID sources in a full conduction,
non-dim state.
• When controlling Lutron 2-wire drivers, refer to driver
spec sheet for permitted driver quantities.
• If mixing Lutron 2-wire drivers and other loads on the
same module, treat each driver as a 50 W load.
Adaptive Dimming Modules
• 115 BTU/hour maximum per module.
• RTISS-TE
TM filter circuit technology compensates for
incoming line voltage variations: No visible icker with
+/− 10% change in RMS voltage/cycle and +/−2% Hz
change in frequency/second.
• Rated to handle a fully loaded electrical circuit (16 A
max). 4 outputs per module. Maximum of 10 A on an
output.
• When programmed to “auto” mode, the unit starts in
reverse-phase and if an incompatible load is detected,
it will convert to forward-phase.
• When controlling Lutron 2-wire drivers, refer to driver
spec sheet for permitted driver quantities.
• If mixing Lutron 2-wire drivers and other loads on the
same module, treat each driver as a 50 W load.
0–10 V- Dimming Modules (TVM)
• Two 0 –10 V- circuits per module.
• Maximum of 12 modules, 24dimming legs total per
panel
• Sink or source 50 mA per output (maximum 750 mA
total per twenty-four outputs).
• 5 BTU/hour maximum per module.
• DIN rail mounted.
• Able to control:
– 0 –10 V-, IEC
® Standard 60929
– 10 – 0 V-
– PWM (Pulse Width Modulation), IEC
® Standard
60929
– DALI
® (Broadcast only), IEC® Standard 62386
• Must be used in conjuction with a 4U dimming module
or XP switching module.
XP Switching Modules*
• Switch legs rated at 16 A.
• Four switch legs per module.
• Patented Softswitch
® circuit eliminates arcing at
mechanical contacts when loads are switched, which
prolongs relay life to a minimum of 1,000,000 cycles
at 16 A.
• 10 BTU / hour per module.
• For additional information, see Lutron
® XP
Specication Submittal (P/N369345).
Motor Modules
• Each module controls four 3-wire 220–240 V~ motors
for applications such as shades, draperies, and
hurricane shutters.
• Individual control outputs use two mechanically
interlocked relays for directional control that prevents
simultaneous operation of both outputs.
ELV Dimming Modules
• 115 BTU/hour maximum per module.
• Rated to handle 16 A
• 4 outputs per module. Maximum of 10 A on an output.
• RTISS-TE
TM filter circuit technology compensates for
incoming line voltage variations: No visible icker with
+/− 10% change in RMS voltage/cycle and +/−2% Hz
change in frequency/second.
Module Specifications
