®
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
GRAFIK Systems OMX-CCO-8 Control Interfaces
OMX-CCO-8 4 09.03.08
Operating Modes
Motorized Window Treatment Channels
Applications
• Integrate the control of motorized window treatments with
GRAFIK Systems in existing applications (retrofi t).
• Integrate the control of motorized window treatments with
a GRAFIK Systems when third party motor controllers are
used.
Operation
• Two or three outputs are grouped together to form a
Motorized Window Treatment (MWT) channel. These
outputs provide the OPEN, STOP, and CLOSE signals to
control third party motor controllers (see diagram below).
• The method in which the OMX-CCO-8 stops motorized
window treatments is selectable to accommodate
different types of motor controllers.
- Pulse the OPEN and CLOSE outputs simultaneously.
- Pulse the most recent output again.
- Pulse a dedicated STOP output (Uses three outputs per
channel. In this confi guration, the OMX-CCO-8 may
have a maximum of 2 MWT channels).
• Set the number of MWT channels from 0 to 4 to fi t your
application.
• Outputs not used in MWT channels may be used as
individual outputs. Example: If there are two MWT
channels, and there are three outputs per MWT channel,
there will be two outputs left over to be used as individual
outputs.
• Outputs may be set as momentary or maintained.
CNONC
Output 1
CNONC
Output 2
CNONC
Output 3
CNONC
Output 4
CNONC
Output 5
CNONC
Output 6
CNONC
Output 7
CNONC
Output 8
COM +V MUX MUX
OPTIONS ADDRESS
1 2 3 4 51 2 3 4 5
2 Outputs per Channel
CNONC
Output 1
CNONC
Output 2
CNONC
Output 3
CNONC
Output 4
CNONC
Output 5
CNONC
Output 6
CNONC
Output 7
CNONC
Output 8
COM +V MUX MUX
OPTIONS ADDRESS
1 2 3 4 51 2 3 4 5
3 Outputs per Channel
Close
Open
Close
Open
Close
Open
Close
Open
Close
Open
Close
Open
Stop Channel 1
Stop Channel 2
2 Individual Outputs
Channel 4
Channel 3
Channel 2
Channel 1