TOWN OF CLAYTON
Engineering & Inspections
111 E. Second St., P.O. Box 879
Clayton, NC 27528
The following checklist to be completed by applicant:
[ ] Completed Application
[ ] Owner’s Consent Form (required if applicant is not the property owner)
[ ] Flood Plain Development Permit if the development request will take place within a floodplain.
[ ] Verification of received or current Wastewater Allocation
[ ] Driveway Permit Application
[ ] Lien Agent Form (required for projects that exceed $30,000) (www.liensNC.com)
[ ] Management Switch Request Form (required if Town of Clayton residential customer)
[ ] Copy of a plot plan OR site plan and/or survey to scale which identifies project boundaries, lot
dimensions, acreage, structures (size and location), setbacks, parking and circulation, impervious
surface area and percentage of lot coverage.
**For residential projects: must include 4 copies of plot plan as defined by the Residential Plot Plan
checklist located on the Engineering and Inspections web page.
**For commercial projects: must include a copy of approved and stamped sited plan.
*Please note that an incomplete plan will result in a delay in the processing of the permit.
Please submit one hardcopy and two (2) digital sets of plans if commercial. Please submit one set of
hardcopy plans if residential to include the following:
Scale Drawings: The plans have been drawn to scale (minimum 1/8" = 1') in ink.
Elevations: Elevation drawings include the front, rear, left side and right side.
Foundation Drawings: Identify all necessary structural details including but not limited to the following:
Footing sizes (thickness and width) and location, foundation type (thickness and width) and location, pier
sizes and locations, girder size and material species, floor joist size, material species, spacing and direction of
span. Locate the structural information at the specific location utilized unless the information is typical.
Choose one foundation type below:
☐ Slab / mono ☐ Crawl / raised ☐ Basement
Floor Plans: Provide a plan for each floor (and attic if planned to be finished). Identify all necessary
structural details including but not limited to the following: Beam and header sizes at each location, the
number of beam and header studs supports, ceiling joist/floor joists/rafter size, type of material, on center
spacing, and direction of span. Provide layouts if engineered systems are specified "by others".
BUILDING & ZONING COMPLIANCE PERMIT