SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
3691143b 2 02.11.20
DimmerIn-Line Dimmer
Vive
Power Failure
• Power failure memory: Should power be
interrupted, the control will return to its previously
set level prior to the interruption when power
is restored
Mounting
• Allow adequate space to ensure convective
cooling of load control. Remove any insulation,
heat generating equipment, or obstructions within
120mm (4.75in) of the load control
• For optimal RF performance, no metal or other
electrically conductive material should be present
within 120 mm (4.75 in) around the top and sides
of the load control. The load control is not suitable
for installation in places where it is fully enclosed in
metal (e.g., metal enclosures, electrical cabinets) or
within metal ceilings
Metal Ceiling Tile Mounting
• Metal ceiling tile grids must have a greater than
3 mm (0.12 in) gap of non-metallic material which
extends the entire length of the tile on at least one
edge. This is often achieved by foam spacers that
are used to prevent tile-to-tile rattling
• Metal ceiling tile grids which are continuous (with
no gap) or those that are interlocked, must have
a total surface area that is less than 81 m
2
(266 ft
2
) for each section. The overall space can
be larger as long as there are non-metallic sections
bordering or intersecting the metal sections
Specifications
Regulatory Approvals
• CE (RMKS model only)
• IDMA (RMMS model only)
Power and Ratings
• 220–240 V~ 50 / 60 Hz
Typical Power Consumption
• < 0.5 W; Test conditions: Load and LED are off
Environment
• Operating temperatures 0°C to 40°C (32°F to
104°F )
• Relative humidity: 0% to 90% non-condensing
• For indoor use only
Communications
• Vive in-line dimmers communicate with the system
through Radio Frequency (RF)
• Dimmer must be located within 18 m (60 ft) line-of-
sight or 9 m (30ft) through walls of a Pico wireless
control, Radio Powr Savr sensor, or Vive hub
• System devices operate at frequencies of 868 MHz,
868 MHz Limited, or 434 MHz Limited
ESD Protection
•
Tested to withstand electrostatic discharge without
damage or memory loss, in accordance with
IEC 61
000-4-2
Surge Protection
• Tested to withstand surge voltages without damage
or loss of operation, in accordance with IEEE C62.41-
1991 Recommended Practice for Surge Voltages in
Low-Voltage AC Power Circuits
