Shift
End:
Check Appropriate Boxes Ok Needs Attention or Repair
Guards (No broken welds, mounted securely, no
visible damage.)
VISUAL CHECKS
Back Up Light (Lights when moving in
reverse.)
Warning Lights (Operational)
Time
Hour Meter Reading (Turn key one "position" forward to check
Hour Reading)
Parking Brake (Set parking brake and
accelerate - parking brake prevents the forklift from
moving.)
Service Brake (Brakes slow forklift without
jerking or locking, brakes are not too soft.)
Tire Condition (No excessive wear/splitting,
good rim condition, tight wheel nuts, no separation of
rubber and rim, proper tire pressure.)
Forks (No cracks or other damage, locking pins work
correctly.)
Carriage, Mast & Backrest
(No broken welds, mounted securely, no visible damage.)
OPERATIONAL CHECKS
Start:
Other Gauges/Instruments
Back Up Alarm (Sounds when moving in
reverse.)
Battery Water Level (Check each battery's
water level - located under seat.)
Battery Power Level (Check LED Display
on Instrument Panel)
Date
*Inspect Forklift Before the Start of Each Shift
Hydraulic Fluid Level & Master
Cylinder Fluid Level (Reservoirs found
under Kick Plate below accelerator)
Steering (Steering wheel turns while stopped,
turns forklift smoothly and precisely, no strange noise
or hesitation.)
Operator/Inspector
Cylinders & Hydraulic Controls
(Hydraulic lines ok, hoses ok, secure connections at
fittings, no damage to or fluid leaking from lift and tilt
cylinders.)
Remarks
Damage/Leaks (No damage to forklift or
puddles of fluid around or under the forklift.)
Chains (Clean, lubricated, no visible wear, equal
tension.)
Specification Plate (Readable)
Environmental Health Safety Rev. 2003