TYPE 4B - Submittal Checklist 10-15-19Permits U:/Building/PermitCenter/NewMillineum10/15/19
1
Note: MUST check with other agencies for their specific requirements. Failure to do so,
could result in significant delay to your permit.
1) Completed Application.
2) Applicant acknowledges that the permits adding square footage to the gross usable
area may be subject to increased assessment of Impact Fees.
3) Special permit from the Zoning Division for “Sales Facility”.
TWO IDENTICAL SETS OF THE FOLLOWING, AS APPLIES:
4) Surveys: Construction survey (less than 1 year old if initial construction per Policy and
Procedure Memorandum # PBO-006), or boundary survey (less than 1 year old, as applies)
with signed and sealed construction site plan, including the location of proposed
improvement, drawn to scale and dimensioned, with easements, rights of way, and any
existing structure locations illustrated, and providing distances or separations to the property
lines and any existing structures.
5) Current Certified Site Plans reflecting proposed work, “Conditions of Approval”, and “Results
Letter”, as applies.
6) Complete Civil Plans to confirm compliance with Site Plan and Building Code regulations
only, or site plan demonstrating accessible route and floor elevations (see Land Development
and Landscaping requirements below for additional required copies to be separately
submitted.)
7) Documentation to support the allowance of work proposed, at reduced setbacks or other
variation from Code requirements. This would include a Base Building Line Waiver.
8) Statement from a licensed contractor, architect, or engineer certifying existing and proposed
building area (or living area for multi-residential). This information can be included in the
construction drawings.
9) Proof of valid Concurrency from the Zoning Division, as applies.
Addition, or Accessory Structure (Shed)
10) Wind design information per Section 1603.1.4 FBC. as applies.
11) Drawings are signed and sealed by a Florida Design Professional.
12) Foundation plans.
13) Floor plans.
14) Roof framing plan with uplift/lateral loads, anchor/connector schedule, as applies.
15) Beam/lintel/header schedule or shown on plan, as applies
16) Floor framing plans, as applies.
17) Stair/handrail/guardrail sections and details, as applies.
17) Exterior elevations of all sides of exterior walls being altered, including design pressures
acting on all openings.
19) Typical wall/column sections.
20) Electrical plans, riser diagrams, load calculations, and panel schedules, as applies.
21) Plumbing plans and riser diagrams, as applies.
22) HVAC equipment schedule with sensible capacity, and plans showing equipment locations
and duct systems, as applies.
23) Florida Energy Efficiency and HVAC sizing calculations, as applies.
24) State Product Approvals meeting Fla Admin Rule 9B-72provided for Windows/Glazing
Protection/Mullions/Exterior Doors/Roof Coverings. Specific model of product being used
identified with designer of record review and approval for design condition.
25) Gas plans and information per 106.3.5.2 FBC, and tanks located on survey/site plan, as
applies.
Sales Facility –Manufactured (Modular) Building
26) Construction drawings, approved by the Florida Department of Community Affairs.
27) Foundation plans, signed and sealed by a Florida Design Professional.
28) Accessibility ramp/handrail/guardrail sections and details, as applies.
29) State Product Approvals meeting Fla Admin Rule 9B-72 provided for Windows/Glazing
protection/Mullions/Exterior Doors/Roof Coverings. Specific model of product being used
identified with designer of record review and approval for design condition.
TYPE 4(B) Permits - Non-Residential (Commercial) and 3 or
More Unit Residential Additions, Accessory Buildings, and
Manufactured (Commercial) Buildings
APPLICATION SUFFICIENCY CHECKLIST*
(102 & 106 P.B.C. Amendments to the Florida Building Code 2017 and Palm
Beach County Unified Land Development Code)
