It is the sole responsibility of the system designer and user to select products suitable for their specific application requirements and to ensure proper
installation, operation, and maintenance of these products. Material compatibility, product ratings and application details should be considered in the
selection. Improper selection or use of products described herein can cause personal injury or product damage.
4091 S. Eliot St., Englewood, CO 80110-4396
Phone 303-781-8486 I Fax 303-761-7939
© Copyright 2018 Industrial Specialties Mfg.
Industrial Specialties Mfg.
and IS MED Specialties
September 7, 2018
The PMBV series three-way ball valves are designed as diverter (selecting) valves. These valves
have a 90-degree handle rotation. Rotating the handle directs the flow to the alternate open port,
shutting off the previously open port completely. This valve uses a lever handle and can be orientated
in four positions. It can also be installed or removed while the valve is under pressure. There are four
screw boss locations available for panel mounting the valve body. Panel mounting requires a 0.75
inch hole and a maximum panel thickness of 0.17 inches.
PMBV Series Diverter Ball Valve
Maximum operating pressure
125psi (8.62bar)
Maximum operating temperature
140° F (60° C)
Ball through hole diameter
0.375 inches (9.5mm)
Left image
The left port and the bottom or common port are
connected while the right port is shut off completely.
Right image
With the handle rotated 90 degrees, the bottom port
and right port are connected while the left port is off.
PMBV Series Diverter Ball Valve Options
Materials Body and Ends White Polypropylene, Black Polypropylene
or Gray PVC
Seal Options Buna-N, EPDM (ethylene propylene) or
Viton® (fluoroelastomer)
End Connection Options 1/4”, 3/8” or 1/2” Hose Barb
1/4”, 3/8” or 1/2 Female NPT
1/8”, 1/4" and 3/8 Male NPT
1/4", 3/8” and 1/2” Push-In
Handle Black, Blue, Red or White ABS Plastic
PMBV Series Diverter Ball Valves