SIGNS
REQUIRED INFORMATION FOR PLANS REVIEW TO OBTAIN PERMIT.
WALL MOUNTED SIGN:
• Show where sign will be located on building.
• What is the makeup of the wall that sign will be attached (plywood, drywall, plaster and
lath, block, brick etc.).
• How will sign be attached (specific details such as 6, 1 & 1/2 inch wood screws, machine
screws, sheet metal screws, toggle bolts, masonry bolts, machine bolts etc.)
• Dimensions of sign (height, length and width).
• What material is the sign made of (wood, plastic, metal, composite etc.)
• Height of sign from walking surface to bottom of sign.
• Electrical details if applicable.
POLE SIGN:
• Show where sign will be located in regards to buildings, parking areas, road ways or
intersections.
• Height of sign from walking or driving surface to bottom of sign.
• Dimensions of sign (height, length and width).
• What material is sign made of (wood, plastic, metal, composite etc.)
• How will sign be attached (specific details such as 6, one and half wood screws, machine
screws, sheet metal screws, toggle bolts, masonry bolts machine bolts etc.).
• Pole signs, one pole or two or more, pole made of wood if so give size such as 4x4 3x4
6x6 etc. Wood round pole give diameter, If metal give type (Steel pipe A53B standard
weight, extra strong, double extra strong or other, give nominal diameter such as 1/2,
3/4, 1 inch etc. Steel tubing A500B square or rectangular, size such as 16x16x1/2,
10x10x1/4 etc. Aluminum 6063 T6 tube, square or rectangular, round pipe.
• How is pole attached to ground (imbedded in concrete or bolted to concrete, width,
thickness, depth and psi of concrete?
• Wind load in MPH (miles per hour) show how wind load was calculated.