Industrial Instrumentation PLOs 2017-2018
Acad Program - Industrial Instrumentation (AAS)
Program Learning
Action Taken (Use of
Assessment Methods
Assessment Results
Outcomes
Results)
1. Instrument Drawings - Read and
interpret instrument drawings while
understanding control logic and
fundamental electrical circuit theory.
Outcome Status: Active/Ongoing
Assessment Year: 2017 - 2018
2. Troubleshooting and Calibration Skills
- Perform basic troubleshooting and
calibration skills necessary for entry level
instrumentation positions along with
demonstrating understanding of safety
hazards and procedures associated with
industrial process control.
Outcome Status: Active/Ongoing
3. Identify Industrial Equipment -
Identify typical industrial equipment
and interface sensors with automatic
controls.
Outcome Status: Active/Ongoing
4. Work Ethics -Demonstrate
punctuality and responsibility
suitable to work place employment
while communicating technical issues
to peers both orally and in writing.
Outcome Status: Active/Ongoing
Result Directly Related to Outcome:
Introduction to PLCs initial lab
exercises recorded from Electricity/
Electronics.
Result Directly Related to Outcome:
Safety tests and PLC Troubleshooting
Calibration Labs (Intro & Advanced).
Result Directly Related to Outcome:
Pressure and Level Measurement
average as well as Industrial Control
Systems Loop Check Lab averages.
Result Directly Related to Outcome:
Introduction to PLCs Communication/
Speech component average. Average of
students prepared for labs with proper
PPE & tools (ICS and Temperature &
Analytical labs).
Reporting Period: 2017 - 2018 EoY
Result Type: Criterion Met
Analysis: 84% of students
successfully completed the
learning outcome.
Reporting Period: 2017 - 2018 EoY
Result Type: Criterion Met
Analysis: 85% of students
successfully completed the
learning outcome.
Reporting Period: 2017 - 2018 EoY
Result Type: Criterion Met
Analysis: 91% of students
successfully completed the
learning outcome.
Reporting Period: 2017 - 2018 EoY
Result Type: Criterion Met
Analysis: 90% of students
successfully completed the learning
outcome.
Action Taken (Use of Results):
The goal for instrument
drawing learning outcome is
on target and will continue to
be evaluated for 2018-19.
Action Taken (Use of Results):
The goal for troubleshooting
and calibration learning
outcomes is on target and will
continue to be evaluated for
2018-19.
Action Taken (Use of Results):
The goal for industrial
equipment learning outcomes
is on target and will continue
to be evaluated for 2018-19.
Action Taken (Use of Results):
The goal for work ethic
learning outcomes is on target
and will continue to be
evaluated for 2018-19.
07/24/2018 Generated by Nuventive Improve Page 1 of 1
