INTERIOR
*PLANS MUST BE A MINIMUM SIZE OF 18X24*
WALLS:
• Lumber size of interior and exterior walls
• Interior and exterior wall covering
• Spacing of framing lumber
• Insulation value
• Header sizes of windows and doors
• Vapor barrier
INTERIOR:
• Dimensions of rooms
• Window and door sizes
• Floor joist size and spacing
- if pre-engineered, manufacturers specifications must be
submitted
HVAC:
• Gas unit
1. show location of furnace and hot water heater
2. show where vented to
3. size of vents
4. location of make-up air vents
5. clearance around unit if in an enclosed room
6. gas shut off location
• Electric unit
1. identify BTU
2. show location of unit
3. location of disconnect switch
ELECTRICAL:
• Show runs
• Indicate branch circuits
• Show location of panel box
• Specify amp service
• Identify wire sizes
• Mark GFCI locations
• Show smoke detectors and how they will be wired in
PLUMBING:
• Identify drain line size
• Specify vent size and location
• Show where the sewer line goes
**NOTE PROPOSED USE OF THIS SPACE & EXISTING USE**
**Floodplain application may be required* May require elevation certificates