Electric Vehicle Infrastructure
Charging Station Quick Reference Guide
Siemens Community Level II & Multi-Level
• Activating a ChargePoint RFID Card
Navigate to www.mychargepoint.net and click the button. Use the guided three step process to create an
account and activate your RFID card. Once completed, your ChargePoint RFID Card is ready for immediate use.
• Using a ChargePoint RFID Card to authenticate a station
Sw
ipe your ChargePoint RFID card by the RFID symbol, . The station display will read “Authenticating…”
Once your card is authorized the top line of the display will read “Authorized” and the bottom will read “Door
Unlocked / Lift Door insert plug” or “Remove Connector from Holster”. You are now authorized and are ready to
plug in your vehicle for charging.
• Charging Status Indicators & Messages
“#1:AVAILABLE / TAP CARD TO START” – Charging station is available for use. Swipe RFID enabled Credit
card or ChargePoint card to begin a charging session.
“CHARGING 00:00:00 / 3.36 kW / TAP CARD TO END” – Vehicle is plugged in and connected to station. The
connection time (HH:MM:SS) and the power consumption are displayed. The middle LED will glow green during
a charging session.
“WAITING / VEHICLE NOT READY” – Station connected to vehicle but vehicle is not ready to charge.
“ENDED / PLUG-OUT AT CAR / TAP CARD TO OPEN” – Charging session has ended due to removal of charge
connector.
“FINISHED / RETURN PLUG TO HOLSTER” – Charging has completed, return connector or remove cord set to
end session.
“SUSPENDED GROUND FAULT / AUTO-RETRY IN 15:00” – Charging session has been stopped due to
ground fault detection. Station will apply power and test for ground fault in 15 minutes. Middle LED will glow
red during a ground fault event.
• Inserting the Charge Connector
Le
vel I: Upon authorization, open front door, insert plug into station socket, shut front door, and plug J1772 charge
connector into vehicle. The J1772 connector will click into place when seated correctly. The vehicle is now
connected and ready to be charged.
Level II: Upon authorization, depress the thumb button located on the top of the J1772 connector and pull out the
charge connector from the holster. Plug the charge connector into the charge port of the vehicle. The connector
will click into place when firmly inserted. The vehicle is now connected and ready to be charged.
• Removing the Charge Connector
Depress the thumb button located on the top of the J1772 connector and pull out the charge connector from the
vehicle charge port. Insert the J1772 charge connector into the holster on the charging station.
• De-Activating a Charging Session
Sw
ipe your ChargePoint RFID card by the RFID symbol. The station display will read “ATTENTION / REALLY
END SESSION / TAP CARD TO END”. Swipe your ChargePoint card again to end the session.
/RXGRXQ&RXQW\+DUPRQ\3DUNDQG5LGH(9&6IHHLQIRUPDWLRQ
7KHIHHIRUXVHRI(OHFWULF9HKLFOH&KDUJLQJ6WDWLRQVDW+DUPRQ\3DUNDQG5LGHLVSHUVHVVLRQ
Loudoun County Harmony Park and Ride EVCS fee information
The fee for use of this Electric Vehicle Charging Station is $1.44 per session.
